The rotating direction is changed in the following order:
- Remove the power
- Push and hold the joystick to the same directions as the valve will go from closed to open
- Connect the power again and keep to hold the joystick a couple of seconds
- The working direction is now changed

The rotating direction is changed in the following order:
- Remove the power
- Unscrew the cover of the controller box
- Change the position of the cables connected to the actuator, please see attached picture
- Reassembly the controller box
- The working direction is now changed

Changing the min. and max. flow temperature is done in the advanced settings menu. The temperature can be set from +5°C to +95°C. See the instructions manual on how to access the advanced settings and change the min and max flow temperature values.

The set supply temperature is changed in the following order:
- Press the joystick shortly
- Increase or decreas the tenperature by moving the joystick to the right or left
- Confirm by pressing the joystick shortly

The settings are changed in the following order:
- Press down the joystick for 4 seconds
- The wrench and the dot and arrow up will be shown
- Press the joystick shortly and the numbers will be flashing
- Change the temperature by moving the joystick to the right to increase the temperature and to left to decrease the temperature
- Confirm by pressing shortly on the joystick
- Press down the joystick for 4 seconds or wait 20 seconds to return to main menu

The settings are changed in the following order:
- Press down the joystick for 4 seconds
- The wrench and the dot and arrow up will be shown
- Press the joystick shortly to the right
- The wrench and the dot and the arrow down will be shown
- Press the joystick shortly and the numbers will be flashing
- Change the temperature by moving the joystick to the right to increase the temperature and to left to decrease the temperature
- Confirm by pressing shortly on the joystick
- Press down the joystick for 4 seconds or wait 20 seconds to return to main menu

The set supply temperature is changed in the following order:
- Press the middle button shortly
- Increase or decreas the tenperature by pressing the right button (increase) or left button (decrease)
- Confirm by pressing the middle button shortly

The settings are changed in the following order:
- Press down the middle button for 4 seconds
- The wrench and the dot and arrow up will be shown
- Press the middle button shortly and the numbers will be flashing
- Change the temperature by pressing the right button to increase the temperature and the left button to decrease the temperature
- Confirm by pressing shortly on the middle button
- Press down the middle button forr 4 seconds or wait 20 seconds to return to main menu

The settings are changed in the following order:
- Press down the middle button for 4 seconds
- The wrench and the dot and arrow up will be shown
- Press on the right button
- The wrench and the dot and arrow down will be shown
- Press the middle button shortly and the numbers will be flashing
- Change the temperature by pressing the right button to increase the temperature and the left button to decrease the temperature
- Confirm by pressing shortly on the middle button
- Press down the middle button forr 4 seconds or wait 20 seconds to return to main menu

Under the cover of the controller unit  is a green connector. On this connector you connect two wires and when the two wires are connected together the T2 temperature is activated. Example of external equipment is the ESBE GSM-module CRB915 (art nr 1705 59 00) where you can swift between the two preset temperature by your cellphone.

NOTE: The signal from the external eqipment must be without any voltage or resistance.

Under the cover of the controller box where is possibilities to connect two wires. When the two wires are connected together the T2 temperature is activated.

Yes, it is possible. Please use Adaptor kit VRG801 with article number 16053300.